Arc welding is a method of joining two pieces of metal into one solid piece. To do this, the heat of an electric arc is concentrated on the edges of two pieces of metal to be joined. The metal melts, while the edges are still molten, additional melted metal is added. This molten mass then cools and solidifies into one solid piece.

A short stick of welding filler metal consisting of a core of bare electrode covered by chemical or metallic materials that provide shielding of the welding arc against the surrounding air. It also completes the electrical circuit, thereby creating the arc. (Also known as SMAW, or Stick Metal Arc Welding.)

Like a stick electrode, MIG wire completes the electrical circuit creating the arc, but it is continually fed through a welding gun from a spool or drum. MIG wire is a solid, non-coated wire and receives shielding from a mixture of gases. (Process is also known as GMAW, or Gas Metal Arc Welding.)

MIG wire group is divided between:
1. Gas Less wire: no gas applicable /CO2 or MIX 25%ARGON + 75% CO2/ - results of welding with GasLess wire is increased spatter and fume/smoke during a welding.
2. FluxCored wire: /GAS ASSISTED/ for welding if process need in short period of time to apply thicker welding layer.
3. Hard Core wire: /GAS ASSISTED/ copper plated for mild steel or just stainless steel wire.

Cored wire is similar to MIG wire in that it is spooled filler metal for continuous welding. However, Cored wire is not solid, but contains flux internally (chemical & metallic materials) that provides shielding. Gas is often not required for shielding. (Process is also known as FCAW, or Flux-Cored Arc Welding.)

A bare metal wire is used in conjunction with a separate flux. Flux is a granular composition of chemical and metallic materials that shields the arc. The actual point of metal fusion, and the arc, is submerged within the flux. (Process is also known as SAW, or Submerged Arc Welding.)

Heating the coated stick electrode and the base metal with an arc creates fusion of metals. An AC and/or DC electrical current is produced by this machine to create the heat needed. An electrode holder handles stick electrodes and a ground clamp completes the circuit.

A less intense current produces a finer, more aesthetically pleasing weld appearance. A tungsten electrode (non-consumable) is used to carry the arc to the workpiece. Filler metals are sometimes supplied with a separate electrode. Gas is used for shielding. (Process is also known as GTAW, or Gas Tungsten Arc Welding.)

Constant Voltage and Constant Current welders are used for MIG welding and are a semi-automated process when used in conjunction with a wire feeder. Wire is fed through a gun to the weld-joint as long as the trigger is depressed. This process is easier to operate than stick welding and provides higher productivity levels. CC/CV welders operate similarly to CC (MIG) welders except that they possess multi-process capabilities - meaning that they are capable of performing flux-cored, stick and even TIG processes as well as MIG.

For MIG welding or Flux-Cored wire welding, wire feeder welders are usually complete and portable welding kits. A small built-in wire feeder guides wire through the gun to the piece.

For MIG, Flux-Cored, or submerged arc welding, automatic wire feeders feed a spool of wire at a constant rate to the weld joint. They are usually mounted onto a fixture in a factory/industrial setting and are used in conjunction with a separate power source.